The system will automatically restart, and the display screen will rotate 90 degrees to display and touch normally. Method 1,If the driver is not installed, execute the following command (Raspberry Pi needs to connected to the Internet):Īfter execution, the driver will be installed.This method only applies to the Raspberry Pi series of display screens, other display screens do not apply. Save the touch parameters (may differ depending on LCD) to nf, as shown in the picture:.You can create a nf file to save the touch parameters (not necessary if file exists).Maybe rebooting is required to make calibration active. Finish the touch calibration following the prompts.Click the Men button on the task bar, choose Preference -> Calibrate Touchscreen.Sudo dpkg -i -B xinput-calibrator_0.7.5-1_b This LCD can be calibrated using a program called xinput_calibrator.Wait A Few Minutes, when the system reboot ok, you can see that. (tested on RaspberryPi 3B+,3B,2B,2B+,1B,ZERO)
#RASPBERRY PI ZERO W PINOUT PDF HOW TO#
If you don't know how to do that,you can refer to the Raspberry Pi office tutorial Step 3: Open terminal(SSH) and install the driver on RaspberryPi This LCD Module need install driver first.
Touch Panel interrupt, low level while the Touch Panel detects touching Supports Raspbian system, ubuntu system ,kali Linux system.High quality immersion gold surface plating.Drivers provided (works with your own Raspbian/Ubuntu directly).Compatible with Raspberry Pi A, B, A+, B+, 2B, 3B, 3B+,4B versions.Supports any revision of Raspberry Pi (directly-pluggable).